Underground joint localization method based on electromagnetic wave and ultrasonic

LI Zongwei; LI Qiwei; WEN Liang; MENG Qingyong

doi:10.13272/j.issn.1671-251x.2016.07.008

Volume 42 Issue 7

Turn off MathJax

Article Contents

Article Navigation > Journal of Mine Automation > 2016 > 42(7): 30-33

LI Zongwei, LI Qiwei, WEN Liang, et al. Underground joint localization method based on electromagnetic wave and ultrasonic[J]. Industry and Mine Automation, 2016, 42(7): 30-33. doi: 10.13272/j.issn.1671-251x.2016.07.008

Citation:

LI Zongwei, LI Qiwei, WEN Liang, et al. Underground joint localization method based on electromagnetic wave and ultrasonic[J]. Industry and Mine Automation, 2016, 42(7): 30-33. doi: 10.13272/j.issn.1671-251x.2016.07.008

Citation:

PDF( 621 KB)

Underground joint localization method based on electromagnetic wave and ultrasonic

doi: 10.13272/j.issn.1671-251x.2016.07.008

LI Zongwei^{1, 2, 3},
LI Qiwei^{1, 2, 3},
WEN Liang^{1, 2, 3},
MENG Qingyong^{1, 2, 3}

1.
China Coal Research Institute， Beijing 100013, China
2.
State Key Laboratory of Coal Resource Efficient Mining and Clean Utilization, Beijing 100013, China
3.
Beijing Mine Safety Engineering Techno

Publish Date: 2016-07-10

Abstract

Abstract

For low localization precision of existing underground personnel localization technologies, an underground joint localization method based on electromagnetic wave and ultrasonic was proposed by analyzing ranging principle of electromagnetic wave and ultrasonic wave as well as application characteristics in underground tunnels. In the method, a ratio of distance between a mobile node and two anchor nodes is obtained by approximate calculation according to logarithmic normal distribution model. Vertical coordinate of the mobile node is obtained by electromagnetic wave ranging method, and horizontal coordinate is gotten by ultrasonic wave ranging method. The Matlab simulation result verifies feasibility and localization precision of the method.